Free certification test prep

NO.387 An EMC NetWorker server has been configured to stage from an adv_file type device upon reaching a high water mark of 80%.
After the staging begins, which rule determines when the staging process ends?

NO.388 Your management has scheduled a critical update to be applied to all of your Windows 2003 servers on a Wednesday evening.
You have an EMC NetWorker backup group that performs full backups of these servers only on weekends, complemented by incrementals the rest of the week. To be safe you decide to perform a full backup of all Windows 2003 systems on a Tuesday evening.
What is the easiest way to achieve this?

NO.389 After initiating a manual save, you receive the following error message:
– 39078
– Save
– SYSTEM error: manual saves are not enabled
What must you check to do a manual save?

NO.390 What must be configured to avoid overloading the NetWorker server in a datazone?

NO.391 A Dell EMC NetWorker administrator is unable to assign a protection group to a workflow. During the configuration, the drop-down does not list that group as a selection.
What is a possible reason for the missing group?

NO.392 The mode of an EMC NetWorker volume was prematurely set to “full”.
Which command can be used to change the status of the volume to “appendable”?

NO.393 A customer has one PowerProtect DD with 6 devices in 3 different MTrees. Each MTree has one DD Boost Device and 1 DD Cloud Tier Device.
How many app-based policies need to be created?

NO.394 A Dell EMC NetWorker environment has a cluster consisting of two physical nodes and one virtual service.
What is the minimum number of NetWorker client resources that must be created to ensure all of the data will be backed up?

NO.395 An EMC NetWorker backup administrator wants to monitor a data protection environment consisting of Avamar, Data Domain, and NetWorker through a single interface. In addition, the administrator wants the ability to configure Avamar replication through the same interface.
Which EMC tool is recommended?

NO.396 A customer is adding new tape devices to an EMC NetWorker server. The command is issued to scan for devices but does not find the new devices.
What is the most likely cause?

NO.397 During a backup, which EMC NetWorker host is responsible for tracking the number of clone copies?

NO.398 What is an advantage of integrating Dell EMC NetWorker Snapshot Management with ProtectPoint?

NO.399 Which device type supports multiplexing?

NO.400 In a Dell EMC NetWorker environment, what uses an embedded SQLite database?

NO.401 Refer to the exhibit.

How many nsrlcpd processes are running in the EMC NetWorker backup environment?

NO.402 Which EMC Net Worker settings control the amount of multiplexing?

NO.403 By default, where are backups written to when using NetWorker?

NO.404 Which virtual environments are supported by NetWorker to back up virtual machines?

NO.405 Refer to the exhibit.

In the NMM backup workflow, which process is shown in the box marked “A”?

NO.406 Which NetWorker resource determines the level of backup performed by the client or group?

NO.407 In Dell EMC NetWorker, what is a purpose for the NetWorker save and recover daemon, nsrd?