Free certification test prep

Q11. When executing a FlashArray upgrade from the FA-405 to a FA-X Series, into which slot on CT1 must the 2 Port InfiniBand Card be installed?

Q12. What is the maximum number of SAS shelves supported for FlashArray//XL?

Q13. Which enablement feature will cause Mirrored Write statistics to appear in the Analysis section of the FlashArray Purity 6.x GUI?

Q14. In a situation where iSCSI cards need to be re-used during a controller upgrade, which is a valid transfer path?

Q15. Which PCIe slot supports 4-port FC cards on FlashArray//XL?

Q16. An Implementation Engineer performs a controller upgrade. What is the command to check I/O health?

Q17. What command will view NVRAM install and update status?

Q18. A customer has purchased a DirectFlash Shelf, but lacks available space in the same rack as the chassis. There is available space in a rack 6m away. What step should be taken prior to implementation?

Q19. Which I/O card type is compatible across all FlashArray models?

Q20. In a situation where FC cards need to be re-used during a controller upgrade, which is a valid transfer path?

Q21. For FlashArray//XL, which 2 PCIe slots should be used for DFS connectivity?

Q22. Before leaving the site after an install, who is required to provide completion sign-off?

Q23. An Implementation Engineer is beginning a controller upgrade. Which command should be run to stop Purity?

Q24. Before proceeding with a controller upgrade, phonehome logs must be sent. What command will verify that the logs have been sent?

Q25. What is the minimum AC voltage required to operate a FlashArray//X20R4 array?

Q26. When transforming an array from SAS to NVMe with the Evergeen XFORM upgrade, when should a swing shelf be installed?

Q27. A customer needs to have arrays installed and configured with ActiveCluster and ETH replication. The installation document contains 3 IP addresses. How many additional IP addresses are needed?

Q28. What is the rack unit height of a FlashArray//XR2/3?

Q29. What should an Implementation Engineer do when installing rails in a threaded-hole rack?

Q30. What is the required PSU wattage for a FlashArray// X70R2/R3 or X90R2/R3 array?

Q31. An Implementation Engineer is performing a capacity consolidation on an X50R2 that is 83% full. The starting config is X50R2-20/10-22/0. The end config is X50R2-91/0. What steps should the Implementation Engineer follow to complete the work?