Free certification test prep

NO.15 Before disconnecting the cables from the NVMe backplane, what precaution should be taken?

NO.16 Exhibit:

Where are the 2 screws located before you can remove the air shroud?

NO.17 Exhibit:

How many screws need to be removed from the support bar located at the rear of the motherboard tray?

NO.18 To disengage a PCIe, motherboard, or GPU tray on the AS-8125GS-TNMR2 system, loosen the screws on either side of the tray, then slowly pull the tray out to disengage it. True or False?

NO.19 When lowering the midplane bracket back into the chassis, what should you make sure to do with all the cables?

NO.20 After removing the screws from the midplane bracket, what cables must be removed?(Choose 2 answers.)

NO.21 Where is the one screw that needs to be removed in order to remove the AOM bracket?

NO.22 Which cables need to be reconnected after installing the NVMe backplane?

NO.23 What could happen to the system if the cables connecting the AOM card to the motherboard are not returned to their proper port locations?

NO.24 Exhibit:

The 2 cables attached to the midplane on the side closest to the PCIe tray that need to be removed are the I2C cable and power cable. True or False?

NO.25 In order to remove the midplane from the AS-8125GS-TNMR2 system, and after you remove all the PSUs, you will need to disengage 3 trays. What is the correct order for disengagement?

NO.26 In the example system configuration shown in the video, is there an AOM card in the right AOM bracket?

NO.27 In the motherboard tray, the AOM bracket is partially covered by the support bar. So, you’ll need to remove the support bar first before you can remove the AOM bracket. True or False?

NO.28 Before removing the midplane from the AS-8125GS-TNMR2, you must disengage all the power supply units (PSUs) and dummy PSUs, as well as the PCIe tray, motherboard tray, and GPU tray. True or False?

NO.29 As shown in the video, when returning any tray (GPU, motherboard, PCIe) back to the chassis, why must you screw in a tray at one end of the chassis first, before installing another tray at the opposite end of the chassis?

NO.30 The SKU for the NVMe backplane is BPN-NVME5-HS219N-S24. True or False?

NO.31 How can the 4 MCIO cables located in the center of the motherboard be released and unlocked?

NO.32 Before removing the midplane from the AS-8125GS-TNMR2, what are some of the required steps?
(Choose 2 answers.)