[Q10-Q34] Exam Passing Guarantee Aug 18, 2026 NSE4_FGT_AD-7.6 Exam with Accurate Quastions!

Rate this post

Exam Passing Guarantee Aug 18, 2026 NSE4_FGT_AD-7.6 Exam with Accurate Quastions!

Test Engine to Practice Test for NSE4_FGT_AD-7.6 Valid and Updated Dumps

Fortinet NSE4_FGT_AD-7.6 Exam Syllabus Topics:

Topic	Details
Topic 1	Firewall Policies and Authentication: This domain focuses on creating firewall policies, configuring SNAT and DNAT for address translation, implementing various authentication methods, and deploying FSSO for user identification.
Topic 2	Routing: This domain covers configuring static routes for packet forwarding and implementing SD-WAN to load balance traffic across multiple WAN links.
Topic 3	Content Inspection: This domain addresses inspecting encrypted traffic using certificates, understanding inspection modes and web filtering, configuring application control, deploying antivirus scanning modes, and implementing IPS for threat protection.
Topic 4	Deployment and System Configuration: This domain covers initial FortiGate setup, logging configuration and troubleshooting, FGCP HA cluster configuration, resource and connectivity diagnostics, FortiGate cloud deployments (CNF and VM), and FortiSASE administration with user onboarding.
Topic 5	VPN: This domain focuses on implementing meshed or partially redundant IPsec VPN topologies for secure connections.

Q10. A network administrator wants to set up redundant IPsec VPN tunnels on FortiGate by using two IPsec VPN tunnels and static routes.
All traffic must be routed through the primary tunnel when both tunnels are up. The secondary tunnel must be used only if the primary tunnel goes down. In addition, FortiGate should be able to detect a dead tunnel to speed up tunnel failover.
Which two key configuration changes must the administrator make on FortiGate to meet the requirements? (Choose two.)

In the phase1-interface, enable npu-offload to detect a dead tunnel.

Configure a lower distance on the static route for the primary tunnel, and a higher distance on the static route for the secondary tunnel.

Enable Dead Peer Detection.

Use the VPN wizard to create an IPsec template for a redundant IPsec VPN tunnel.

Q11. You have configured the below commands on a FortiGate.

What would be the impact of this configuration on FortiGate?

FortiGate will enable strict RPF on all its interfaces and porti will be exempted from RPF checks.

FortiGate will enable strict RPF on all its interfaces and porti will be enable for asymmetric routing.

The global configuration will take precedence and FortiGate will enable strict RPF on all interfaces.

Port1 will be enabled with flexible RPF. and all other interfaces will be enabled for strict RPF

Q12. Refer to the exhibit showing a debug flow output.

Which two conclusions can you make from the debug flow output? (Choose two.)

The default gateway is configured on port2.

The RPF check fails.

The debug flow is for UDP traffic.

The matching firewall policy denies the traffic.

Q13. Refer to the exhibits.

The exhibits show a diagram of a FortiGate device connected to the network, and the firewall configuration.
An administrator created a Deny policy with default settings to deny Webserver access for Remote-User2.
The policy should work such that Remote-User1 must be able to access the Webserver while preventing Remote-User2 from accessing the Webserver.
Which two configuration changes can the administrator make to the policy to deny Webserver access for Remote-User2? (Choose two.)

Set the Destination address as Webserver in the Deny policy.

Disable match-vipin the Deny policy.

Set the Destination address as Deny_IP in the Allow_access policy.

Enable match-vipin the Deny policy.

Q14. A network administrator enabled antivirus and selected an SSL inspection profile on a firewall policy. When downloading an EICAR test file through HTTP, FortiGate detects the virus and blocks the file. When downloading the same file through HTTPS, FortiGate does not detect the virus and does not block the file, allowing it to be downloaded.
The administrator confirms that the traffic matches the configured firewall policy. What are two reasons for the failed virus detection by FortiGate? (Choose two.)

The selected SSL inspection profile has certificate inspection enabled.

The website is exempted from SSL inspection.

The El CAR test file exceeds the protocol options oversize limit.

The browser does not trust the FortiGate self-signed CA certificate.

Q15. Refer to the exhibits.

An administrator wants to add HQ-ISFW-2 in the Security Fabric. HQ-ISFW-2 is in the same subnet as HQ-ISFW. After configuring the Security Fabric settings on HQ-ISFW-2, the status stays Pending. What can be the two possible reasons? (Choose two answers)

Upstream FortiGate IP must be set to 10.0.11.254.

SAML Single Sign-On must be set to Manual.

HQ-ISFW-2 must be authorized on HQ-ISFW.

Management IP must be set to 10.0.13.254.

Q16. Refer to the exhibit.

A partial cloud topology is shown.
You deployed a FortiGate Cloud-Native Firewall (CNF) in AWS for FortiGate CNF policy enforcement for EC2 instance traffic. Which path does the EC2 traffic take from the EC2 instance to the internet?

EC2 instance # GWLBe # FortiGate CNF # GWLBe # IGW # internet

EC2 instance # Internet Gateway (IGW) # Gateway Load Balancer (GWLB) # FortiGate CNF # internet

EC2 instance # FortiGate CNF # GWLB # GWLBe # IGW # internet

EC2 instance # GWLB endpoint (GWLBe) # FortiGate CNF # IGW # internet

Q17. Refer to the exhibits. The exhibits show the system performance output and default configuration of high memory usage thresholds on a FortiGate device.

Based on the system performance output, what are the two possible outcomes? (Choose two.)

FortiGate has entered conserve mode.

Administrators can access FortiGate only through the console port.

Administrators can change the configuration.

FortiGate drops new sessions.

Q18. Refer to the exhibit. Why is the Antivirus scan switch grayed out when you are creating a new antivirus profile for FTP?

None of the inspected protocols are active in this profile.

FortiGate, with less than 2 GB RAM, does not support the Antivirus scan feature.

Antivirus scan is disabled under System -> Feature visibility.

The Feature Set for the profile is Flow-based but it must be Proxy-based.

Q19. Refer to the exhibits.

An administrator has observed the performance status outputs on an HA cluster for 55 seconds.
Which FortiGate is the primary?

HQ-NGFW-1 with the parameter memory-failover-flip-timeout setting

HQ-NGFW-2 with the parameter priority setting

HQ-NGFW-1 with the parameter override setting

HQ-NGFW-2 with the parameter memory-failover-threshold setting

Q20. Refer to the exhibits. The exhibits show the system performance output and default configuration of high memory usage thresholds on a FortiGate device.

Based on the system performance output, what are the two possible outcomes? (Choose two.)

FortiGate has entered conserve mode.

Administrators can access FortiGate only through the console port.

Administrators can change the configuration.

FortiGate drops new sessions.

Q21. An administrator configures FortiGuard servers as DNS servers on FortiGate using default settings.
What is true about the DNS connection to a FortiGuard server?

It uses UDP 53.

It uses DNS over HTTPS.

It uses DNS over TLS.

It uses UDP 8888.

Q22. Refer to the exhibit. What would be the impact of these settings on the Server certificate SNI check configuration on FortiGate?

FortiGate will accept and use the CN in the server certificate for URL filtering if the SNI does not match the CN or SAN fields.

FortiGate will accept the connection with a warning if the SNI does not match the CN or SAN fields.

FortiGate will close the connection if the SNI does not match the CN or SAN fields.

FortiGate will close the connection if the SNI does not match the CN and SAN fields

Q23. Refer to the exhibits.

The exhibits show the application sensor configuration and the Excessive-Bandwidth and Apple filter details. Based on the configuration, what will happen to Apple FaceTime if there are only a few calls originating or incoming? (Choose one answer)

Apple FaceTime will be allowed, based on the Video/Audio category configuration.

Apple FaceTime will be blocked, based on the Excessive-Bandwidth filter configuration.

Apple FaceTime will be allowed, based on the Apple filter configuration.

Apple FaceTime will be allowed only if the Apple filter in Application and Filter Overrides is set to Allow.

Q24. A FortiGate firewall policy is configured with active authentication, however, the user cannot authenticate when accessing a website.
Which protocol must FortiGate allow even though the user cannot authenticate?

LDAP

TACASC+

Kerberos

DNS

Q25. An administrator wants to ensure that a specific firewall policy on FortiGate is matched before any other policies for the same traffic. Which configuration change is most appropriate?

Enable central NAT

Increase the policy ID number

Move the policy higher in the policy list

Change the policy schedule to always

Q26. The FortiGate device HQ-NGFW-1 with the IP address 10.0.13.254 sends logs to the FortiAnalyzer device with the IP address 10.0.13.125. The administrator wants to verify that reliable logging is enabled on HQ-NGFW-1.
Which exhibit helps with the verification?

Q27. Refer to the exhibit. Which two statements are true about the routing entries in this database table? (Choose two.)

All of the entries in the routing database table are installed in the FortiGate routing table.

The port2 interface is marked as inactive.

Both default routes have different administrative distances.

The default route on port2 is marked as the standby route.

Q28. A network administrator has enabled full SSL inspection and web filtering on FortiGate. When visiting any HTTPS websites, the browser reports certificate warning errors. When visiting HTTP websites, the browser does not report errors.
What is the reason for the certificate warning errors?

The browser does not trust the certificate used by FortiGate for SSL inspection.

The option invalid SSL certificates is set to allow on the SSL/SSH inspection profile

The matching firewall policy is set to proxy inspection mode.

The certificate used by FortiGate for SSL inspection does not contain the required certificate extensions.

Q29. Which three statements explain a flow-based antivirus profile? (Choose three.)

FortiGate buffers the whole file but transmits to the client at the same time.

Flow-based inspection uses a hybrid of the scanning modes available in proxy-based inspection.

If a virus is detected, the last packet is delivered to the client.

Flow-based inspection optimizes performance compared to proxy-based inspection.

The IPS engine handles the process as a standalone.

Q30. Refer to the exhibits. The exhibits show the system performance output and default configuration of high memory usage thresholds on a FortiGate device.

Based on the system performance output, what are the two possible outcomes? (Choose two.)

FortiGate has entered conserve mode.

Administrators can access FortiGate only through the console port.

Administrators can change the configuration.

FortiGate drops new sessions.

Q31. Refer to the exhibit. Based on the routing table shown in the exhibit, which two statements are true? (Choose two.)

A packet with the source IP address 10.100.110.10arriving on port3 is allowed if strict RPF is disabled.

A packet with the source IP address 10.100.110.10arriving on port2 is allowed if strict RPF is enabled.

A packet with the source IP address 10.0.13.10arriving on port2 is allowed if strict RPF is disabled.

A packet with the source IP address 10.10.10.10arriving on port2 is allowed if strict RPF is enabled.

Q32. Which two statements about the Security Fabric rating are true? (Choose two answers)

A license is required to obtain an executive summary in the Security Rating section.

The root FortiGate provides executive summaries of all the FortiGate devices in the Security Fabric.

The Security Posture category provides PCI compliance results.

Security Rating Insights are available only in the Security Rating page.

“The Security Rating page is separated into three major scorecards: Security Posture, Fabric Coverage, and Optimization, which provide an executive summary of the three largest areas of security focus in the Security Fabric .” ( Fortinet Document Library )
“On the root FortiGate , go to Security Fabric > Security Rating.” ( Fortinet Document Library )
“The Info and Compliance tab includes the security controls used for the test and links to specific FSBP, PCI, or CIS compliance policies .” ( Fortinet Document Library )
“A new Security Rating Insights feature provides immediate access to crucial security information. Hover over any tested object to reveal a tooltip…” and “Objects, such as firewall policies, with security rating recommendations are highlighted… click Security Rating Insights to display relevant issues.” ( Fortinet Document Library ) Technical Deep Dive:
The correct answers are B and C .
B is correct because Security Rating is viewed from the root FortiGate and its scorecards provide an executive summary for the Security Fabric, not just an isolated downstream unit. The root device is the point from which the Security Fabric summary is presented. ( Fortinet Document Library ) C is correct because the Security Rating results include an Info and Compliance view with references to PCI compliance policies. That means PCI-related compliance results are part of the Security Rating reporting associated with the security categories, including Security Posture. ( Fortinet Document Library ) Why the others are incorrect:
* A is incorrect because Fortinet documents state there is a base set of free checks and a separate licensed set of checks. A license is not required just to obtain the executive summary view itself. ( Fortinet Document Library )
* D is incorrect because Security Rating Insights are not limited to the Security Rating page. Fortinet documents show they also appear as tooltips and buttons on other GUI objects and pages . ( Fortinet Document Library )

Q33. Refer to the exhibits.

You are asked to implement an antivirus profile for files downloaded through FTP, HTTP, and HTTPS.
While testing, you are successful with HTTP and FTP protocols, but FortiGate does not block the file download over HTTPS.
What could be the cause?

The feature set in the antivirus profile is not set to Flow-based.

Web filter is not enabled on the firewall policy to complement the antivirus profile.

The action on the firewall policy is not set to deny.

The SSL inspection mode in the firewall policy is not deep content inspection.

Q34. Refer to the exhibits. The exhibits show a diagram of a FortiGate device connected to the network, and the firewall policies, VIP, and IP pool configurations on the FortiGate device.
The WAN (port2) interface has the IP address 100.65.0.101/24.
The LAN (port4) interface has the IP address 10.0.11.254/24.
The first firewall policy has NAT enabled using the IP pool. The second firewall policy is configured with a VIP as the destination address.
Which IP address will be used to source NAT (SNAT) the internet traffic coming from a workstation with the IP address 10.0.11.50?