Free certification test prep

Q185. Refer to the exhibit.

An administrator is troubleshooting a time synchronization problem for the router time to another Cisco IOS XE-based device that has recently undergone hardening. Which action resolves the issue?

Q186. Refer to the exhibit.


An OSPF neighbor relationship between R2 and R3 is showing stuck in EXCHANGE/EXSTART state. The neighbor is established between R1 and R2. The network engineer can ping from R2 to R3 and vice versa, but the neighbor is still down. Which action resolves the issue?

Q187. Refer the exhibit.

Which action resolves intermittent connectivity observed with the SNMP trap packets?

Q188. Refer to the exhibit.

Which statement about R1 is true?

Q189. An engineer configured a Cisco router to send reliable and encrypted notifications for any events to the management server. It was noticed that the notification messages are reliable but not encrypted. Which action resolves the issue?

Q190. Refer to the exhibit.

An administrator that is connected to the console does not see debug messages when remote users log in. Which action ensures that debug messages are displayed for remote logins?

Q191. Two MPLS routers, R1 and R2, are not directly connected and have an established LDP session running between them. What type of LDP session is this?

Q192. Refer to the exhibit.

An IP SLA was configured on router R1 that allows the default route to be modified in the event that Fa0/0 loses reachability with the router R3 Fa0/0 interface. The route has changed to flow through router R2. Which debug command is used to troubleshoot this issue?

Q193. Refer to the exhibit.

Users in the branch network of 2001:db8:0:4::/64 report that they cannot access the Internet. Which command is issued in IPv6 router EIGRP 100 configuration mode to solve this issue?

Q194. Refer to the exhibit.

Users report that IP addresses cannot be acquired from the DHCP server The DHCP server is configured as shown About 30O total nonconcurrent users are using this DHCP server, but none of them are active for more than two hours per day Which action fixes the issue within the current resources”

Q195. A network administrator executes the command clear ip route. Which two tables does this command clear and rebuild? (Choose two.)

Q196.

Refer to the exhibit Which action ensures that 10 10 10 0/24 reaches 10 10 20 0/24 through the direct link between R1 and R2?

Q197. Which SNMP verification command shows the encryption and authentication protocols that are
used in SNMPV3?

Q198. Refer to the exhibit. An engineer has successfully set up a floating static route from the BRANCH router to the HQ network using HQ_R1 as the primary default gateway When the g0/0 goes down on HQ_R1, the branch network cannot reach the HQ network 192.168.20.0/24. Which set of configurations resolves the issue?

Q199. Refer to the exhibit. An engineer is troubleshooting a routing loop on the network to reach the
172.16 3.0/16 from the OSPF domain. Which configuration on router R1 resolves the issue?

Q200. Refer to the exhibit.

An engineer is trying to configure local authentication on the console line, but the device is trying to authenticate using TACACS+ Which action produces the desired configuration?

Q201. Clients on ALS2 receive IPv4 and IPv6 addresses but clients on ALS1 receive only IPv4 addresses and not IPv6 addresses. Which action on DSW1 allows clients on ALS1 to receive IPv6 addresses?

Q202.

An engineer sets up a DMVPN connection to connect branch 1 and branch 2 to HQ branch 1 and branch 2 cannot communicate with each other. Which change must be made to resolve this issue?