Free certification test prep

NEW QUESTION 257
Refer to the exhibit. Your company designed a network to allow server VLANs to span all access switches in a data center.
In the design, Layer 3 VLAN interfaces and HSRP are configured on the aggregation switches.
Which two features improve STP stability within the network design? (Choose two.)

NEW QUESTION 258
An architect receives a business requirement from a CTO that states the RTO and RPO for a new system should be as close as possible to zero. Which replication method and data center technology should be used?

NEW QUESTION 259
Refer to the exhibit, Company XYZ is a large enterprise network where the WAN traffic utilizes most of the link. The IT team in the company often reports Stuck-In-Active problems. The company is set to acquire another company that will also be running EIGRP and which will connect to the Company XYZ R3 and R4 routers. This acquisition could make the issue worse.
Which design solution solves this problem?

NEW QUESTION 260
Refer to the exhibit. The WAN network of the General Bank of Greece has experienced several outages. It takes too long to activate a new branch site. The networking department of the bank plans to upgrade the legacy end-of-life WAN network with a new flexible, manageable, and scalable in-house solution. The number of branches will increase exponentially in the next fiscal year. The CTO states that the bank’s main goal is OPEX reduction. The network engineering team prepares a table to evaluate the available options. Which WAN technology can be used for the solution?

NEW QUESTION 261
Company XYZ is running a redundant private WAN network using OSPF as the underlay protocol. The current design accommodates for redundancy in the network, but it is taking over 30 seconds for the network to reconverge upon failure. Which technique can be implemented in the design to detect such a failure in a subsecond?

NEW QUESTION 262
Two routers R1 and R2 are directly connected through an Ethernet link. Both routers are running OSPF over the Ethernet link and OSPF has been registered with BFD. R1 has been set up to transmit BFD at a 50 ms interval, but R2 can receive only at a 100 ms rate due to platform limitations. What does this mean?

NEW QUESTION 263
You want to split an Ethernet domain in two.
Which parameter must be unique in this design to keep the two domains separated?

NEW QUESTION 264
Which two technologies enable multilayer segmentation? (Choose two.)

NEW QUESTION 265
An enterprise that runs numerous proprietary applications has major issues with its on-premises server estate hardware, to the point where business-critical functions are compromised. The enterprise accelerates plans to migrate services to the cloud. Which cloud service should be used if the enterprise wants to avoid hardware issues yet have control of its applications and operating system?

NEW QUESTION 266
Company XYZ wants to secure the data plane of their network. Which two technologies can be included in the security design? (Choose two)

NEW QUESTION 267
Which three components are part of the foundational information security principles of the CIA triad? (Choose three.)

NEW QUESTION 268
A company is reviewing their technology roadmap ahead of their cloud journey The as-is assessment found that a large inventory (5000+) of servers sees less than 50% capacity utilization Which cloud architecture model supports the company to optimize the resource utilization’?

NEW QUESTION 269
Company XYZ is planning to deploy primary and secondary (disaster recovery) data center sites. Each of these sites will have redundant SAN fabrics and data protection is expected between the data center sites. The sites are 100 miles (160 km) apart and target RPO/RTO are 3 hrs and 24 hrs, respectively. Which two considerations must Company XYZ bear in mind when deploying replication in their scenario? (Choose two.)

NEW QUESTION 270
Network operators have many options available from fully centralized to fully distributed control planes and each approach has its own set of characteristics Drag and drop the characteristics from the left onto the corresponding approach on the right

NEW QUESTION 271
Refer to the exhibit.

An engineer has been asked to redesign the traffic flow toward AS 111 coming from AS 500.Traffic destined to AS 111 network 91 7 0.0/16 should come in via AS 100. while traffic destined to all other networks in AS 111 should continue to use the existing path Which BGP attributes are best suited to control this inbound traffic coming from BGP AS 500 Into the 91.7.0.0/16 network?

NEW QUESTION 272
What is the best approach to ensure both scalability and high availability for a cloud-based storage solution over the IP network?

NEW QUESTION 273
Company XYZ connects its sites over a private WAN. Their overlay network is running a DMVPN setup where the headquarters site is the hub. The company is planning on implementing multicast routing on the network. What should be used in the multicast routing design?

NEW QUESTION 274
You have been tasked with designing a data center interconnect as part of business continuity. You want to use FCoE over this DCI to support synchronous replication. Which two technologies allow for FCoE via lossless Ethernet or data center bridging? (Choose two.)

NEW QUESTION 275
Which two advantages of using DWDM over traditional optical networks are true? (Choose two.)