Free certification test prep

QUESTION 23
A BIG-IP system receives UDP traffic from a specific source. The administrator wants the traffic to be forwarded, not dropped or rejected. Which virtual server type should be used? (Choose one answer)

QUESTION 24
The diagram below shows the TCP connection setup for an application.

Which of the following virtual server types applies? (Choose one answer)

QUESTION 25
Which three iRule events are likely to be seen in iRules designed to select a pool for load balancing? (Choose three.)

QUESTION 26
What is the result when a BIG-IP Administrator manually disables a pool member? (Choose one answer)

QUESTION 27
The BIG-IP appliance fails to boot. The BIG-IP Administrator needs to run the End User Diagnostics (EUD) utility to collect data to send to F5 Support. Where can the BIG-IP Administrator access this utility?

QUESTION 28
An application is configured so that the same pool member must be used for an entire session, and this behavior must persist across HTTP and FTP traffic. A user reports that a session terminates and must be restarted after the active BIG-IP device fails over to the standby device.
Which configuration settings should the BIG-IP Administrator verify to ensure proper behavior when BIG-IP failover occurs? (Choose one answer)

QUESTION 29
A BIG-IP Administrator is making adjustments to an iRule and needs to identify which of the 235 virtual server configured on the BIG-IP device will be affected. How should the administrator obtain this information in an effective way? (Choose one answer)

QUESTION 30
Which of the following lists theorder of preference from most preferred to least preferredwhen BIG-IP processes and selects avirtual server? (Choose one answer)

QUESTION 31
A BIG-IP Administrator is making adjustments to an iRule and needs to identify which of the 235 Virtual Servers configured on the BIG-IP device will be affected. How should the administrator obtain this information in an efficient way?

QUESTION 32
A BIG-IP Administrator configures remote authentication and needs to make sure that users can still login even when the remote authentication server is unavailable. Which action should the BIG-IP Administrator take in the remote authentication configuration to meet this requirement?

QUESTION 33
Refer to the exhibit above.




A BIG-IP pool is configured with Priority Group Activation = Less than 2 available members. The pool members have different priority groups and availability states. Which pool members are receiving traffic?
(Choose one answer)

QUESTION 34
An organization needs to deploy an HTTP application on a BIG-IP system. The requirements specify hardware acceleration to enhance performance, while HTTP optimization features are not required.
What type of virtual server and associated protocol profile should be used to meet these requirements?
(Choose one answer)

QUESTION 35
What is the result when a BIG-IP Administrator manually disables a pool member? (Choose one answer)

QUESTION 36
A BIG-IP Administrator makes a configuration change to a Virtual Server on the Standby device of an HA pair. The HA pair is currently configured with Auto-Sync enabled. What effect will the change have on the HA pair configuration? (Choose one answer)

QUESTION 37
Refer to the exhibit above.




A BIG-IP pool is configured with Priority Group Activation = Less than 2 available members. The pool members have different priority groups and availability states. Which pool members are receiving traffic? (Choose one answer)

QUESTION 38
A BIG-IP Administrator assigns the default HTTP health monitor to a pool that has three members listening on port 80. When the administrator connects to each pool member using the curl utility, two of the members respond with a status of 404 Not Found, while the third responds with 200 OK. What will the pool show for member availability? (Choose one answer)

QUESTION 39
What command will assist the BIG-IP Administrator in finding the tmm routes when in the TMSH CLI?

QUESTION 40
A BIG-IP Administrator has acluster of devices.
What should the administrator doafter creating a new Virtual Server on device 1? (Choose one answer)

QUESTION 41
Refer to the exhibit.

During a planned upgrade to a BIG-IP HA pair running Active/Standby, an outage to application traffic is reported shortly after the Active unit is forced to Standby. Reverting the failover resolves the outage. What should the BIG-IP Administrator modify to avoid an outage during the next failover event? (Choose one answer)

QUESTION 42
A virtual server is listening at 10.10.1.100:80 and has the following iRule associated with it:
when HTTP_REQUEST { if { [HTTP::header UserAgent] contains “MSIE” }
{ pool MSIE_pool }
else { pool Mozilla_pool }
If
a user connects to http://10.10.1.100/foo.html and their browser does not specify a UserAgent, which pool will receive the request?

QUESTION 43
A BIG-IP Administrator has a cluster of devices.
What should the administrator do after creating a new Virtual Server on device 1? (Choose one answer)

QUESTION 44
The BIG-IP Administrator wants to provide quick failover between the F5 LTM devices that are configured as an HA pair with a single Self IP using the MAC Masquerade feature. The administrator configures MAC masquerade for traffic-group-1 using the following command:
`tmsh modify /cm traffic-group traffic-group-1 mac 02:12:34:56:00:00`
However, the Network Operations team identifies an issue with using the same MAC address across multiple VLANs. As a result, the administrator enables Per-VLAN MAC Masquerade to ensure a unique MAC address per VLAN by running:
`tmsh modify /sys db tm.macmasqaddr_per_vlan value true`
What would be the resulting MAC address on a tagged VLAN with ID 1501? (Choose one answer)

QUESTION 45
A BIG-IP is configured with a pool member located on a different subnet that is not local to the BIG-IP. To ensure that the return traffic from the pool member is sent to the client through the BIG-IP, a Source NAT (SNAT) is used and configured for SNAT Automap. The BIG-IP has a default gateway on the external VLAN, a floating and non-floating self-IP address on each VLAN, and a management address. Which IP address will the BIG-IP use as the source address for the traffic to the pool member when client traffic is sent through the virtual server?